- Easy fill system with tank markers
- 2.5L capacity
- Telescopic handle with trigger release
- Lightweight yet highly effective
- Portable and compact
- Free 500ml bottle of carpet shampoo in every pack
Cascade Manual Carpet Shampooer
If vacuuming your carpets isn’t leaving them looking bright and fresh, then a carpet shampooer is what you need. The Cascade is robust and easy to operate with its telescopic handle and simple trigger release of shampoo.
The roller with twin brush strips work the active shampoo deep into the carpet fibres. The shampoo is designed to lift dirt from the carpet fibres and as the foam dries, any residue can simply be vacuumed away once the carpet is dry, leaving clean and fresh smelling carpets.
Each Cascade Manual Carpet Shampooer comes with a 500ml bottle of carpet shampoo so you can get cleaning straight away.
Cascade manual carpet shampooer & 500ml Carpet Shampoo with oxy action
Easy fill system with tank markers
Telescopic handle with trigger release
Lightweight yet highly effective
Free 500ml Carpet Shampoo with oxy action in every pack
Large capacity 2.5L tank
Product dimensions HWD: 100 x 24 x 44 cm
Product weight: 1.4 kg
Vacuum the carpet to remove surface debris before applying the foam shampoo.
It is advisable to test the carpet for colour fastness prior to use. To do this, mix a little of the foam shampoo and water to the specified dilution, apply to a clean cloth and then clean a small area of carpet, ideally one which is normally hidden from view.
For best results the shampoo should be mixed: 10 part water to 1 part shampoo i.e. 10 cups of water to 1 cup of shampoo, or using the filling marks on the rear of tank produces the same results (10 to 1 mix).
How to use your Ewbank Cascade
- How to fill
Turn the filler cap at the top of the tank 1/4 turn to the right and remove.
- Marking on tank
Add water to the water level marked on the tank then add shampoo to the shampoo level for cleaning large areas. Replace the filler cap and turn 1/4 turn to the left. If spot cleaning, mix 300ml (10 oz.) water to 30 ml (1 oz.) shampoo.
- Press the handle release
Press down on the top of the handle release button then extend the handle by gently pulling upwards until handle locks in place.
- Using the trigger
When the handle is locked in positions you will feel a spring loaded action in the trigger.
Squeezing the trigger will release the valve in the head of the unit allowing the shampoo and water mixture to be applied to the foam roller. Using short overlapping strokes the mixture will be applied to the carpet or rug – DO NOT OVERWET the cleaning area. Releasing the trigger will stop the flow of shampoo/water mixture, although the roller will remain wet for a time afterwards. After use let the carpet or rug dry completely, then vacuum or use your carpet sweeper to remove the deposits lifted by the foam shampoo.
Note: The drying of the carpet generally takes 3-4 hours.
How to clean your Ewbank Cascade Carpet Shampooer
After use pour out any unused solution and clean by rinsing out the tank with a small amount of clean water. Pull up on the trigger a number of times to run the clean water through the system. Clean the head by rinsing the roller and brushes under a tap. The shampooer must be thoroughly clean and dry before storing.
Removing the roller
If necessary you can remove the roller and brush head assembly for cleaning. Do this by inserting a flat head screw driver between the main moulding and the brush rocker arm and gently levering out.